Amana Tool 51625 Aluminum Chamfer Edge 3/16 D x 3/32 CH x 1/4 SHK x 2 Inch Long x Single Flute SC ZrN Coated Up-Cut End

Amana Tool 51625 Aluminum Chamfer Edge 3/16 D x 3/32 CH x 1/4 SHK x 2 Inch Long x Single Flute SC ZrN Coated Up-Cut End Mill

$100.77

SKU: 51625 Amana Tool

Only 5 left!
Cutting Dia3/16″
Cutting Length3/32″
Shank1/4″
Flutes1
CutUpcut

Description

Up-Cut – Single flute – 45° Chamfer Designed to route a finished appearance into aluminum, brass, copper & non-ferrous metals in one pass, these Amana Tool end mills utilize the ‘O’ flute up-cut design for a super-clean finish. By combining the up-cut design along with the common 45° chamfer, you can maximize your efficiency by routing one single pass. The Zirconium Nitride (ZrN) coating creates a harder and tougher cutting ceramic over carbide edge, allowing for a prolonged cutting edge life and helps to prevent the build-up/galling of material in the flutes while cutting. Amana’s combination end mill/router bits offer the flexibility to cut the chamfer along with the proven performance of the up-cut design for superior chip ejection. Materials: Aluminum, Brass, Copper, Non-Ferrous Metal. WARNING! : Never attempt to cut ferrous metals with these bits. Inspect cut quality and adjust feed / speed accordingly. Note: For optimal results and extended tool life use mist lubricant system or air cooling.

Feeds & Speeds
Based on published chip-load charts. Full calculator →
Cut not coming out right? Melting, chipping, burning or tearout — the Cut Doctor reads your settings (or a photo of the edge) and gives you the cause, corrected numbers, and the bit that fixes it. Free, no signup.